Devices

Gateway:  3000X Series  

The Gateway 3000X Series is centred around the Intel® Quark SoC X1021. The Quark’s intricately integrated System on Chip construction provides high functionality with low power consumption, allowing 3000X devices to deliver significant savings without compromising performance. As in the preceding generation, the 3000X boasts an absence of mechanical parts along with all the reliability increases implied by such design.

The Gateway 3000X Series features up to 1GB of built-in RAM capacity supported by an 8MB NVRAM SPI NOR Flash Chip.

Gateway:  3000 Series  

The Gateway 3000 Series is a single-board computer design, based on the powerful ARM9 EP9302 processor. The key benefit of a single-board computer is the absence of mechanical parts, which means that the product is much more reliable and less prone to break down due to wear. 

The Gateway 3000 Series features up to 32 MB of NAND flash memory, and has the ability to run high speed SDRAM.

Gateway:  2000 Series  

The 2nnn.1002 series is designed for remote data acquisition via the Internet. Each Gateway has 10 inputs, 8 of which are user-programmable to receive analogue or digital signals. The remaining 2 inputs accept digital inputs only. Remote control is possible with 2 sets of normally open contacts. 

Analogue inputs can be 4-20mA or 0-5V while digital inputs can be volt-free contacts or 5VDC.

This series supports built-in PSTN, 10base-T Ethernet and external PSTN, GSM, GPRS, ACeS, WiFi, RF or VSAT connectivity.

Ideally suited for applications like:-

• Condition Monitoring 
• Power Management, Trending
• Scientific and Industrial data acquisition

Gateway:  1000 Series 

The 10nn.1002 series is designed for exception-based monitoring. It has 10 volt-free contact inputs, 1 open collector and 1 normally open contact output. Internet connectivity to the iSCADA server is via a built-in PSTN modem or an external GSM modem. Legacy appliances can be monitored and managed remotely through the Internet by simply retrofitting this low cost device.   

I/O expansion up to 160 inputs and 32 outputs is easily achieved by cascading additional Slave devices. 

Ideally suited for applications like:-

• Building Facility Management
• Environmental Monitoring
• Monitoring of remote or unmanned assets

SLAVE  1000 Series  

Input Channels 

A total of 10 input channels are provided. These are user-programmable as Analogue or Digital inputs. A Digital input can be a relay contact or a DC (0 or 5V) signal. A maximum of 5 channels can be programmed as analogue channels (0 – 5V) to monitor parameters like temperature, pressure and liquid level. Sensors are not included.

Local network failure detection 

The Slave devices connects to each other and the Gateway via a pair of RS485 cable. Any failure in the communication cable will be detected and the affected Slave device reported to the iSCADA server.

Devices Log File 

The 01.1002 model is an Internet Gateway and a data logger combined. A non-volatile log file of the last 90 events is kept locally at the Device. The user may upload this log file for analysis.